EdgeProbe Nano

Compact Monitoring Probe for Digital TV Networks

Compact monitoring probe for digital TV networks

EdgeProbe Nano is the most compact monitoring probe of the EdgeProbe family, with no compromise on quality. In a 140 x 140 mm housing, it monitors RF signals at transmitter outputs or off-air through its RF input, and baseband links at modulator inputs and head-ends through its ASI and IP inputs. It runs standalone or with a network monitoring system, and is available for DVB-T/T2, DVB-C/C2 and ISDB-T/Tb.

Transport conformance follows ETSI TR 101 290 priorities 1, 2 and 3.

Highlights

Accurate RF Quality Monitoring

Signal level, MER, SNR and BER, modulation parameters (L1 signaling, TPS), RF spectrum and constellation, and channel impulse response. DVB-T and DVB-T2 (1.1.1, 1.2.1, 1.3.1), T2 Lite, single and multi-PLP reception.

SFN Synchronisation

RF frame delay and drift, carrier frequency offset and drift, and TS network delay (MIP or T2-MI), to identify which TX site causes an SFN issue. Echo delay and level alarms at reception sites.

TS Monitoring & Forwarding

ASI and IP inputs for baseband links, with forwarding of the analyzed TS or T2-MI over ASI or IP and VLAN support.

Complete TS Monitoring

ETSI TR 101 290 priorities 1, 2 and 3, optional QoS indicators, regionalization checks (service plan, PID and service presence, scrambling), and service and component bitrates.

T2-MI Monitoring

Single or multi-PLP, T2-MI packet alarms, L1 pre/post signaling, network delay, PLP extraction and TS PLP analysis.

Storage & Recording

32 GB internal storage: alarm logs and RF trends up to 6 months, and TS or T2-MI recording triggered manually or through SNMP.

Small, Silent, Magnetized

A 140 x 140 x 30 mm unit that installs anywhere. Standalone, no PC required, 8 W power consumption.

Remote Access & Automation

HTML5 web GUI usable over low-bandwidth control links (GPRS/3G), SNMP v2c and INFORM for alarms and configuration, and about 15 minutes for the first configuration.

Internal GNSS (Option)

GPS and GLONASS receiver generating an internal 1PPS reference for SFN measurements.

Applications

  • Network operators
    • Automating new transmitter tests, temporary monitoring or investigation, and rebroadcast reception (RF to ASI or IP), with a compact monitoring probe
  • Broadcasters
    • Off-air monitoring to validate on-air content
  • TV and STB producers
    • Automated tests against a professional receiver
  • Labs
    • Easy access to live DTV sources and a live transmission recorder

Other Benefits

  • Small, silent and magnetized: install this compact monitoring probe anywhere
  • Remote access, compatible with low-bandwidth control networks (GPRS/3G)
  • Portable tool for maintenance teams
  • Easy to use: standalone, no PC required, about 15 minutes for the first configuration
  • SNMP test automation and low power consumption (8 W)

Technical specifications

RF Monitoring

Frequency range

40 to 1000 MHz; channel bandwidths 1.7, 5, 6, 7 and 8 MHz

Sensitivity

-80 to -5 dBm, RF lock down to -80 dBm

Signal level

-90 to -5 dBm, ±1 dBm (typically ±0.5 dBm), 0.2 dBm resolution

MER and SNR

MER 0 to 40 dB; SNR 0 to 40 dB (±1 dB)

BER

DVB-T pre/post-Viterbi and post-RS; DVB-T2 pre/post-LDPC and post-BCH

Standards

DVB-T (ETSI EN 300 744); DVB-T2 and T2 Lite (ETSI EN 302 755); T2-MI (ETSI TS 102 773)

SFN Monitoring

At TX site

RF frame delay and drift; carrier frequency offset (±1 Hz, 0.1 Hz resolution)

Distribution network delay

TS (MIP) or T2-MI delay between the broadcast gateway and the remote TX site, measured before the modulator

At RX site

Channel impulse response with echo delay and power alarm masks, and Echo Pattern monitor

Baseband & TS Monitoring

Inputs

1 ASI in/out (BNC, 75 Ω) and 1 Gigabit Ethernet data in/out with VLAN support

IP link

UDP/RTP, network jitter, RTP packet errors, FEC

MPEG-2 TS

ETSI TR 101 290 priorities 1, 2, 3; optional QoS indicators (SAE, SDE); service plan, PID and service presence, scrambling, bitrates, PSI/SI decoding

T2-MI and OneBeam

T2-MI packet alarms, L1 pre/post signaling, PLP extraction; OneBeam monitoring

Round-robin

Sequential monitoring of several channels on one RF input

Storage & Logs

Internal storage

32 GB

History

Alarm logs and RF trends up to 6 months

Recording

TS and T2-MI recording, manual or SNMP-triggered

Interfaces & Integration

Control

1 Gigabit Ethernet: HTML5 web GUI, SNMP v2/v2c/INFORM, FTP

Time reference

1PPS input (BNC); optional GNSS antenna input (SMA, GPS/GLONASS)

Remote access

Web GUI over low-bandwidth links (3G, GPRS)

Physical & Environment

Dimensions

30 mm (H) x 140 mm (W) x 140 mm (D)

Power

12 VDC, external 100-240 VAC adapter included; 8 W

Operating temperature

-20 to 50 °C

Humidity

0 to 95 %, non-condensing

Licensing & Options

Versions

EdgeProbe Nano DVB-T/T2, DVB-C/C2 and ISDB-T/Tb

ACCESS

RF monitoring, round-robin, ETSI TR 101 290 priorities 1, 2, 3

PERFORMANCE

ACCESS + service plan and multiplex view

ULTIMATE

PERFORMANCE + IP monitoring (jitter, RTP FEC), T2-MI monitoring and OneBeam monitoring

Hardware option

Internal GNSS receiver (EPA3-GNSS)

Warranty

1-year hardware warranty with basic helpdesk; optional Advance and Premium hardware and software support for 1, 3 or 5 years

Ordering codes

EdgeProbe RF — DVB-C/C2

Base RF monitoring probe

EdgeProbe RF — ISDB-T/Tb

Base RF monitoring probe

EdgeProbe RF — DVB-T/T2

Base RF monitoring probe

EdgeProbe Nano — DVB-C/C2

Compact monitoring probe

EdgeProbe Nano — ISDB-T/Tb

Compact monitoring probe

EdgeProbe Nano — DVB-T/T2

Compact monitoring probe

EdgeProbe Advanced — DVB-C/C2

Full-featured monitoring probe

EdgeProbe Advanced — ISDB-T/Tb

Full-featured monitoring probe

EdgeProbe Advanced — DVB-T/T2 / DVB-S/S2 / ATSC 1.0-3.0 / DAB+

Full-featured monitoring probe

Options

Internal GNSS receiver

Internal 1PPS reference signal generation for SFN synchronisation

Dual Power Supply

Power redundancy

For more informations on

EdgeProbe Nano