EdgeProbe Advanced

Multistandard Monitoring Probe for Broadcast Networks

Multistandard monitoring probe for broadcast networks

EdgeProbe Advanced is the full-featured multistandard monitoring probe of the EdgeProbe family: any two RF standards in one 1RU device, with up to four parallel monitoring modules (two per RF standard). It monitors RF signals through up to four RF inputs, and baseband transport before the modulator through ASI and IP inputs, standalone or with a network monitoring system.

Complete MPEG-2 TS monitoring follows ETSI TR 101 290 priorities 1, 2 and 3.

Highlights

DVB-T/T2 Monitoring

Up to 2 RF inputs per 1RU. Level, MER, SNR and BER, modulation parameters (L1 signaling, TPS), channel impulse response. DVB-T, DVB-T2 (1.1.1, 1.2.1, 1.3.1) and T2 Lite.

DVB-S/S2/S2X Monitoring

Up to 2 RF inputs per 1RU. Level, CNR, Eb/N0, link margin and BER, multistream, LNB powering and configuration, L-band (950-2150 MHz after downconversion), C, Ku and Ka bands.

ISDB-T/Tb Monitoring

Up to 2 RF inputs per 1RU. Level, MER, SNR and BER per layer A/B/C, TMCC and layer parameters, channel impulse response.

DVB-C/C2 Monitoring

Up to 2 RF inputs per 1RU. Level, MER and BER, modulation parameters and L1 part 2 signaling for C2.

ATSC 1.0/3.0 Monitoring

RF spectrum and shoulders, level, SNR, MER, BER with LDPC iterations, TX ID decoding, STLTP link monitoring, Lighthouse scenario decoding and ATSC 1.0 TS monitoring per ETSI TR 101 290.

DAB/DAB+ Monitoring

Monitored in the same 1RU device, combined with another RF standard.

SFN Synchronisation

RF frame delay and drift, carrier frequency offset and drift, to identify which TX site causes SFN problems.

Baseband Monitoring & TS Forward

TS, T2-MI and BTS links monitored through ASI and IP inputs (up to 4 per 1RU), with forwarding of the analyzed TS over ASI or IP, T2-MI PLP extraction and VLAN support.

Complete MPEG-2 TS Monitoring

ETSI TR 101 290 priorities 1 to 3, optional QoS indicators, regionalization checks, and service and component bitrates.

T2-MI, BTS & OneBeam Monitor

T2-MI packet alarms, T2 L1 pre/post signaling, PLP analysis and extraction, BTS IIP/TMCC monitoring, and OneBeam T2-MI markers and in-band PID monitoring.

Storage, Logs & History

32 GB internal storage per unit (up to 4 per 1RU), alarm logs and RF trends up to 6 months, manual TS recording. Options: internal GNSS receiver and dual power supply.

NMS Compatibility & Remote Access

Works with any network monitoring system through SNMP v2c and v2c INFORM. The web GUI is usable over low-bandwidth connections (3G, GPRS).

Applications

  • 24/7 monitoring and maintenance of head-end and TX sites
    • SFN, MFN and retransmission networks, with a multistandard monitoring probe in RF and baseband
  • 24/7 monitoring of uplink and downlink sites
    • RF and baseband
  • Service availability reports
    • Quality reports for SLA commitments
  • RF-to-ASI or IP gateway
    • Demodulated, analyzed TS forwarded over ASI or IP
  • Live transmission log
    • RF trends and TS recorder

Other Benefits

  • Satellite distribution and terrestrial, cable and DAB RF monitored in one 1RU multistandard monitoring probe
  • Standalone, easy to configure, fast to deploy and SNMP compatible
  • Early detection of degradations, to prevent customer complaints and reduce site maintenance costs
  • Network planning support by revealing global trends
  • Remote access over low-bandwidth networks (GPRS/3G/4G), with a power consumption of 25 W

Technical specifications

RF Inputs & Standards

RF inputs

Up to 4, N-type female (50 Ω) or F-type female (75 Ω) depending on the RF standard

Standards per 1RU

Any 2 among DVB-T/T2, DVB-S/S2/S2X, DVB-C/C2, ISDB-T/Tb and ATSC 1.0/3.0; DAB/DAB+ combined with another RF standard

Frequency range

DVB-T/T2, DVB-C/C2, ISDB-T/Tb: 40 to 1000 MHz; DVB-S/S2: 950 to 2150 MHz after LNB downconversion

Sensitivity

RF lock from -80 to -5 dBm

DVB-T/T2 RF

RF measurements

Level, MER, SNR, BER; up to 2 RF inputs per 1RU

Modulation

L1 signaling (T2), TPS (T)

Channel

Channel impulse response

Standards

DVB-T; DVB-T2 1.1.1, 1.2.1, 1.3.1; T2 Lite

DVB-S/S2/S2X RF

RF measurements

Level, CNR, Eb/N0, link margin, BER; up to 2 RF inputs per 1RU

Modulation

Multistream, modulation parameters

LNB

Powering and configuration

Frequency

L-band 950-2150 MHz after LNB downconversion; C, Ku, Ka bands

ISDB-T/Tb & DVB-C/C2 RF

ISDB-T/Tb

Level, MER, SNR, BER per Layer A/B/C; TMCC; channel impulse response

DVB-C/C2

Level, MER, BER; modulation parameters; L1 part 2 signaling (C2)

ATSC 1.0/3.0 RF & SFN

RF

RF spectrum, shoulders; level, SNR, MER (L1-Basic, L1-Detail, PLP), BER with LDPC iterations

TX SFN

RF frame drift

Reception SFN

Echo impulse response with TX ID decoding; up to 4 RF inputs per 1RU

STLTP link

IP jitter, FEC (packet loss and recovery), SFN sync (network delay), STLTP integrity

Lighthouse

PLP and service list decoding, bitrate and channel usage

SFN Synchronisation

Measurements

RF frame delay and drift; carrier frequency offset and drift

Purpose

Identifies the faulty TX site

Baseband & TS Forward

Inputs

Up to 4 ASI in/out (BNC, 75 Ω) and up to 4 Gigabit Ethernet data in/out with VLAN support

Forwarding

Analyzed TS over ASI or IP; T2-MI PLP extraction

T2-MI / BTS / OneBeam

ETSI TR 101 290 T2-MI alarms; T2 L1 pre/post signaling; T2-MI PLP analysis; BTS IIP/TMCC; OneBeam markers and in-band PID

MPEG-2 TS

ETSI TR 101 290 priorities 1-3; optional service availability and degradation QoS; regionalization; service and component bitrates

Storage & Interfaces

Storage

32 GB internal per unit (up to 4 per 1RU); alarm logs and RF trends up to 6 months; manual TS recording

Control

Up to 2 Gigabit Ethernet: web GUI, SNMP v2/v2c/INFORM, FTP

Time reference

1PPS and 10 MHz inputs (BNC); optional GNSS antenna input (SMA, GPS/GLONASS)

Remote access

Web GUI over 3G, GPRS or 4G

Physical & Environment

Format

1RU, 19-inch rack: 45 mm (H) x 440 mm (W); 145 mm deep with 1 or 2 monitoring units, 300 mm with 4

Power

100-240 VAC ±10%; 25 W; redundant power supply optional

Operating temperature

-20 to 55 °C

Humidity

0 to 95 %, non-condensing

Licensing & Options

Versions

EdgeProbe Advanced DVB-C/C2, ISDB-T/Tb and DVB-T/T2; multistandard DVB-T/T2, DVB-S/S2, ATSC 1.0/3.0 and DAB+

Software packs

ACCESS, PERFORMANCE and ULTIMATE (ULTIMATE is available on EdgeProbe Advanced only)

Hardware options

Internal GNSS receiver; dual power supply; tropicalization against corrosion

Warranty

1-year hardware warranty with basic helpdesk; optional Advance and Premium hardware and software support for 1, 3 or 5 years

Ordering codes

EdgeProbe RF — DVB-C/C2

Base RF monitoring probe

EdgeProbe RF — ISDB-T/Tb

Base RF monitoring probe

EdgeProbe RF — DVB-T/T2

Base RF monitoring probe

EdgeProbe Nano — DVB-C/C2

Compact monitoring probe

EdgeProbe Nano — ISDB-T/Tb

Compact monitoring probe

EdgeProbe Nano — DVB-T/T2

Compact monitoring probe

EdgeProbe Advanced — DVB-C/C2

Full-featured monitoring probe

EdgeProbe Advanced — ISDB-T/Tb

Full-featured monitoring probe

EdgeProbe Advanced — DVB-T/T2 / DVB-S/S2 / ATSC 1.0-3.0 / DAB+

Full-featured monitoring probe

Options

Internal GNSS receiver

Internal 1PPS reference signal generation for SFN synchronisation

Dual Power Supply

Power redundancy

For more informations on

EdgeProbe Advanced